Oracle-audio-technologies V User Manual

ORACLE AUDIO DELPHI MARK V turntable 1 OWNER’S MANUAL by Oracle Audio Technologies inc

... attach the ground lead - Loosen the thumb nut from under the sub-chassis near the tonearm and insert one end of the lead. - Attach the other

11Check: - drive belt - motor connection plug for a broken wire - drive module for a broken wire - defective drive module ... if the

12 to firmly secure the screws. Do not forget to add the content of one oil vial (about 3 cc) before installing the platter. - As a precauti

T ABLE OF CONTENTS Foreword ... 1 How to ... ..

ow to ... ... pack and unpack your Delphi H - Remove the inner box by lifting it straight up and out. Open the flaps on both ends and slide out

4 - Locate the bearing assembly in the lower section of the packaging. Remove the 3 mounting screws. - Locate the tool kit in the lower sec

5Important ! If you are planning to cut your own mounting board, remember that the cutting of the arm board can sometimes be troublesome as well a

6 changing the position of the spring in its holder. The color coding is visible from the inside at the wider end of the spring. Note 2:

- Place the subchassis over the suspension modules. - Install the platter without the drive belt. - Locate the suspension gauge in the documentati

8 be done by simply lifting the suspension housing just enough so you can see the spring. If you can see the spring anywhere from almost fl

9 Note 3: In the event that the drive belt becomes contaminated, clean it with denatured alcohol. Clean the motor pulley and the drive hu